Forum Replies Created
Viewing 8 posts - 1 through 8 (of 8 total)
Viewing 8 posts - 1 through 8 (of 8 total)
Yeah that would be great. I also have a Qu system and a GLD system and I want to avoid buying a AB168. I always use an AR2412 with the Qu and it would be nice if I could use a second AR2412 on the GLD instead of an AB168 on the extender port.
Very nice. I will try it out this week. Is it the Dugan algorithm?
@john-s
It’s about protection, storage and handling. I would prefer another AR2412 but you cannot connect more than one in one (GLD) system 😉
@eotsskleet
Thanks, I will go with the rack mount solution as there seems to be enough space for the side connections.
We use the app for monitor mixing from the stage without any problems (iPad Air). Note that you have to double tap the AUX to set is as mix.
Thanks A&H, we will update and retry the procedure above.
Unfortunately I cannot answer your question. Just have experience with the Waves card and SoundGrid. But I have a question: do you use the Dante virtual sound card or the dante pci card? How about latency without a SoundGrid server? Does it work well for live processing?
Best regards
Toby
Last weekend we got a surface freeze, too. It happend while configuring custom faders in the iPad app. The meters on the app were also frozen. Fortunately it came back to life after a few seconds.
Software version was 1.41.
Best regards from Germany
Toby
Hi ahjeff,
I’ve tried to send the dSNAKE, the EXPANDER and the “normal” control network connection via one ethernet cable to the stage to an AR2412 and an AR84. Every port is set to its own VLAN and a 1 Gbit/s (VLAN tagged) trunk to the other switch is set up. When there is no traffic on the control network connection, the connection to the stage boxes work flawlessy. But as soon as I connect GLD editor and there’s traffic on the control network I got QOS erros on the dSNAKE and EXPANDER connections. I’ve turned off broadcast storm control. Unfortunately I’ve had only Netgear GS108Ev2 switches to test. I will retest with some HP ProCurve 2626 and report.
Do you have any recommandations for such a setup with compact switches (at least on the surface side)?
Best regards from Germany
Toby