Don’t know if this is too late, but I currently run an sq6 at my church. We don’t use as many outputs, but this should work, and is just an expansion of @markpaman:
- Main LR – (Left main speaker amp, Right main speaker amp) This is your main mix and it is stereo.
- Matrix 1 – (Mono Center Speaker amp) I’m guessing your room was previously LCR, So pull the Mix LR to the matrix.
- Matrix 2 – Assuming the same signal you want to send to the other monos(Mono output to Hearing Loop amp and Mono output to main entrance/building speakers amp) is the same, you will only need one matrix. If the level sends need to be different, than you will need to use Matrix 3 as well.
- Mix 1 – (Mono Sub amp) Subs
- Mix 2 – (Mono monitor mix to stage (set up as one of the fader layers?)) Not exactly sure what you mean by “fader layers”. When you select a mix, all the individual channel faders become the selected mix level send for that channel, just like the main.
- Mix 3-8 – (Stereo monitor mixes to stage (controlled over wireless with App))
- Mix 9-12 – Aux or groups. You can have 12 total, so 12 groups, or 12 auxes, or 6 auxes and 6 groups(you get the idea).
I trust my people, so I haven’t locked anything down. As far as number of outputs, you can patch anything to anywhere. You could have 10 physical sockets all outputting the MainLR – L channel.
As far as you box placement(AR2412), I don’t know where your connections are. You will need more outputs than that box provides as 6 stereo = 12 sockets. If you only need more outputs, check out the DX012. You probably also know that the AR2412 is 48K, while the SQ’s are 96K.
Don’t know if that helps, but there’s my 2 cents.
