[BCParticipant]

Dx168 to GigaAce on Avantis as well as waves module thru waves server & soundgrid channel to channel then out slink to built in slink on sq5 tie lined to expansion slink module to me1. Mains to stream which is where I’d like control of waves plugins as well. I get 32 channels from Avantis with FOH controlled channels into sq5.

[BCParticipant]

It populates ‘input socket’ in Me1, but not Channel names from Avantis. When I deactivate tielines on sq5 it populates names of sq5 mixer.

[BCParticipant]

Can dx hub connect to GigaAce on Avantis then out of same GigaAce & TO GigaAce card on sq5 via Tie line config? We have me1 on slink, dx hub to GigaAce & waves3 card in other slot. I need to get digital split to sq5 GigaAce. The whole system is ran through Avantis foh & a meu to me1s for musicians & for stream. Upgraded to sq5 for stream but need to get audio to it hopefully w/o running thru sq5 first. OR can dx Ethernet out be split to 2 mixers? Or is there a dx hub w multiple outs? Or do I have to connect meu to slink on sq5 to open slink on Avantis for digital split out to new GigaAce card on sq5? Manuals for products would be nice. Redundancies only option? Network bridge? Thanks.

[BCParticipant]

I have all the iem on dcas but need to dig into internal routing of me1s from mixer if I up the verb or adjust faders on snare for instance, it changes in musician’s ears from me1

[BCParticipant]

When I adjust foh faders it also adjusts me1 levels & fx. I recently came in to this church & system was in place. Musicians complain when I adjust faders or fx on channels as it also adjusts their mix on me1. I would like to isolate them from foh mix to their own mix with desired fx etc. meu dx168 dx hub avantis waves

[BCParticipant]

So how do you route me1 outputs independent of foh so you can send wet mix to house & dry mix to musicians on me1s? ….meu dx168 dx hub avantis waves

[Author]

Posts