hi / lopass filter on main out eq

Forums Forums dLive Forums dLive feature suggestions hi / lopass filter on main out eq

This topic contains 6 replies, has 4 voices, and was last updated by Profile photo of SteffenR SteffenR 5 years, 7 months ago.

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • #55259
    Profile photo of mumu
    mumu
    Participant

    maybe i missed something but its not there…..
    if i assign a third master (the one i ve found so far – mono) to run subs separately,
    i love to have a filter on this.

    #55428
    Profile photo of mumu
    mumu
    Participant

    well…
    hi/lo pass on all the mixes….

    #55429
    Profile photo of mervaka
    mervaka
    Participant

    Can you not feed your sub mix full range? I’m assuming you have some sort of speaker management if you have a dLive..

    #55521
    Profile photo of mumu
    mumu
    Participant

    of course i do, but sometimes i travel with my band with the console, end up in strange clubs with strange monitors, f.o.h. systems.
    this feature would allow better/easyer control.

    #55528
    Profile photo of Andrew
    Andrew
    Participant

    Either use the Graphic Equaliser available on each mix, or set the LF band of the PEQ to a low-cut filter.

    #55540
    Profile photo of mumu
    mumu
    Participant

    thats what i do of course but the “real” filter has a 24db butterworth (*_*)

    #55707
    Profile photo of SteffenR
    SteffenR
    Participant

    filters aditionally is a good idea

Viewing 7 posts - 1 through 7 (of 7 total)

You must be logged in to reply to this topic.