[RobJParticipant]

Yes, have the RTA layered on the EQs of all outgoing channels. It seems as if most other apps already have this. Makes me think it would not be that difficult.

[RobJParticipant]

3.Spectrum analyser or RTA Overlay on EQ page
-Spectrum analyser on PEQ per channel.
-Spectrum analyser on GEQ for all output with.

– RTA/spectro on EQ screen, because now it can be very time consuming when using it.

This

[RobJParticipant]

Hi,

Is there a way on the QU-Pac to control the output balance? I know it was added to the QU APP, but I can’t find a way to control it from the QU-Pac control panel. I’m sure I’m missing something simple. Any help would be greatly appreciated.

[RobJParticipant]

Excellent Bob. Thanks. Can’t wait to get the Qu-PAC tomorrow and play around with it. I’m assuming all those recording functions can be set in soft keys and be done remotely?

[RobJParticipant]

Thanks so much for the replies. I have a Sandisk Extreme 32gb on the way. Also a WD Elements 500gb HD. So if I understand right, when I stop the recording, it will finish writing the files. Then when I start it again by arming the unit and it will create another directory for the next round of multitrack files? When finished, I would have 5 or 6 different directories, one for each act. I can then use tracks 17 and 18, if set up that way, to make a stereo file, dither down to 44.1 and 16bit and put on a CD to give out?

Rob

[RobJParticipant]

Awesome Robbo. I think I have to wait a little longer on this side of the pond. Enjoy and give a report back as soon as you can.

[RobJParticipant]

Hey Robbo,

Congrats! When do you think you will get it? If you don’t mind me asking, who did you order with? I can’t find it in stock yet.

mamerica, I’m wondering if maybe he should have been wearing the Joker costume.

[RobJParticipant]

Excellent Andreas. Thanks. That makes it easy. If I understand right, the softkeys can be assigned to record and stop stereo or multitrack recording. Gosh I can’t wait to get my hands on the Qu-pac.

[RobJParticipant]

Hey Bob,

I know not one product cannot be everything for everybody, but since you asked. For me I was hoping to have the ability to leave the QU-pac on stage and not have to use a snake in a small place, think coffee house, small bar etc. Let’s say you have an all acoustic show with 5 to 10 acts like an open mic or benefit concert and you’d like to make multitracks and give them to the performers. Each act may only be using 2 inputs (solo artist with guitar) or be using up to 10 inputs (5 instruments and singers). I was hoping to be able to arm and unarm tracks as needed. I guess you could just leave 10 tracks armed all the time and delete the unused tracks after the show.

[RobJParticipant]

Thanks GC and Bob.

You’re right Bob. I had grabbed the quick start guide and reference guide, but hadn’t quite gotten to page 72 yet. Then I found this.

Setup functions not available:
• FX patching
• Local/dSNAKE Preamp source selection
• Global Qu-Drive/USB B source selection
• Insert switching and channel linking
• Output patching
• Aux source routing options
• Matrix sends and routing
• Show memory store and load
• Scene Recall Filters and Safes edit
• Copy/Paste/Reset of parameters
• Signal Generator
• Talkback
• System configuration, options and preferences

Was hoping to be able to have complete access of the Setup functions in case I wanted to use the QU-Pac on very small gigs and leave it on stage and do everything remotely.

[Author]

Posts