[nottooloudParticipant]

Still looking for this in Stereo Tap Delay and BBD.

[nottooloudParticipant]

you can use the Copy/Paste keys with the blue Mix keys to quickly copy and paste all the routing from one mix to another

That works until you change a pan in the main mix during a show.

[nottooloudParticipant]

If it’s playback music, you just need to make sure that all of the sends are post fader. Then as you pull down the channel fader, everything else comes down too.

[nottooloudParticipant]

Well, happened here, too. Booted up the SQ6, nothing else running. No touchscreen response. Rebooted the board, all is well. Scary.
@keithjah, are there any diagnostics or anything I can run?

[nottooloudParticipant]

I’m not sure when that gets pushed to main. The current Mac beta is 1.8.0(326). You may be able to switch to the beta release track in the app general settings. I don’t remember if that was a thing I had to sign up for.

A&H should really fix this in firmware. It’s some kind of buffer overrun that should be handled more gracefully.

[nottooloudParticipant]

I would love to not have to check if last night’s mix tech set anything stereo. Recall the house default scene and go to work.

[nottooloudParticipant]

If you send the voices only to tops that are crossed at 200, you are high passing them at 200.

[nottooloudParticipant]

Were you using any control apps? Mixing Station can cause this by sending too much data too fast. Fixed in the current beta.

[nottooloudParticipant]

You could also simply high pass the mics.

[nottooloudParticipant]

You can still set the listen buss level in the menu and from SQ MixPad.

[nottooloudParticipant]

My lockup may have been caused by Mixing Station. David has discovered that if you send data to an SQ too quickly, all kinds of bad things can happen. There’s some kind of buffer overflow. Mine dropped off the network, and then when I rebooted it, the touchscreen didn’t work. Rebooted again with a longer pause and it was fine. He’s going to put data rate limiting into Mixing Station.

[nottooloudParticipant]

My SQ6 screen went unresponsive Saturday. Fine after reboot.

[nottooloudParticipant]

Mixing Station works for that. I use it all the time to keep board recordings from clipping.

[nottooloudParticipant]

I came here today to ask for this, too.

You are limited by the amount of output paths (12).

Well, no, that’s not true. Mains have outs. Matrixes have outs. Why not FX sends? My stageboxes have 16outs. The desk has 14 more. They’re all assignable. Don’t need any processing on them, nothing computationally expensive.

[nottooloudParticipant]

I’ll only record USB out to a laptop. SQ Drive is way too finicky and unreliable.

[Author]

Posts