[mjjohnParticipant]

ALT output work flawlessly, Meters read the same and headphone output also works normal no problem recording to QU-Drive either. Do you think it might be a bad solder joint at the XLR output? Can i do what you have suggested, with a multi-meter?

[mjjohnParticipant]

I have the same problem on Version 1.94. Have tried three different flash drives from different manufactures(SanDisk, PNY, Lexar), all of them skipped some portion of the recording (1-3 Second not recorded, at random points on the track). Please fix this issue, never had this problem on 1.93.

[mjjohnParticipant]

My Left output also has this problem although mine works, signal strength is about 9db lower than the right XLR Main output. My just randomly appeared, did not fix after full reset or an update either. I have posted about this a while ago.

[mjjohnParticipant]

SteffenR: Yes, i am losing around 3-5 db on the left channel compared to the Right Channel. Bob: I have tried different XLR Cable, no luck unfortunately. Is this issue easily fixable?

[mjjohnParticipant]

Its in the center, i checked that while troubleshooting. I have tried hard reset which did not fix the problem. Both output work under alternate out.

[mjjohnParticipant]

Thanks Everyone for the clarifications. I was able to use the matrix flawlessly.

[mjjohnParticipant]

Thanks Mike. Bob; Yes I mainly need to add time alignment delay to the zones. Another confusion: what exactly does Matrix All Sends View page do. Do I use that screen to turn ON or OFF mixes going to the respective matrix. When i experimented with that page when i press the green ON button under Mix 1, Mix 2 etc it just switches between pre or post. is that suppose to do that or does it turn off the signal going to the matrix?

[mjjohnParticipant]

Thank You. That seems simple and easy. So will the signal going to MTX be affected if the main LR is adjusted?

[Author]

Posts