[Kermit911Participant]

Thanks for all the help everyone, I spoke with Sweetwater and I could use the Mix and Groups but I only have 8 of them. The short answer is, the Aviom system I have is not designed to work with the mixer I have. The Aviom I have uses 16 1/4″ plugs to get signal from 16 individual channels. I’m going to get a different board that will work with the Aviom I have. Thanks again everyone.

[Kermit911Participant]

That stinks. I have 5k worth of Aviom gear that is dead in the water. So if I utilize the mix and groups that should give me…. 8 outputs that I could connect to the Aviom. I just have to figure out how to assign a single channel to 1 output now. Thank for the info.

Dave

[Kermit911Participant]

Hello, it’s not a mixer it’s a monitor system. 16 channels from the mixer to the Aviom, then up to the stage via cat5e then to a Avion switch then to individual aviom control boxes. Each box can controle the volume of the 16 channels.

Thanks for the ideas, I dont know how using the USB would work. The Aviom box has nothing but 1/4 inch line inputs.

Thanks
Dave

[Kermit911Participant]

I found these, I am going to give them a try

https://www.ebay.com/itm/MixTagz-Blank-Magnetic-Mixer-Labels-Mixing-Board-Console-Tape/321662054032?hash=item4ae48d6e90:g:rQ4AAOSwHPNbHazm

[Author]

Posts