[josiaspiconeParticipant]

I used one Emerson for 2 idr10 and 2 144, works realy great.

Solo se que no se nada

[josiaspiconeParticipant]

thanks a lot

Solo se que no se nada

[josiaspiconeParticipant]

would be interesting a multiband compresor on the fx section, with mono or stereo options, so if you want to apply compression to a group of channels just use the send to that fx, and if you want to apply compression to one channel just made an insetion.

sorry about my Tarzan english style

Solo se que no se nada

[josiaspiconeParticipant]

Hello

I used in this way: I send teh signal by two mono groups, and unassigned that channel from Mains, then I turn on one compressor.

Sorry about my Tarzan style english[]

Solo se que no se nada

[josiaspiconeParticipant]

Would be good if in the editor could position the faders by clicking on the scale, rather than sliding, and if you please enlarged buttons sel and mix.[]

Solo se que no se nada

[josiaspiconeParticipant]

The error is discovered one hour after the “update”. The editor was connected at that moment, but I was not using the editor. I had made changes in the mix config screen. After the error restart the system with my laptop connected. The error continues to occur. Unplug the laptop, and the error continued. I did a “touch screen Reboot” and the error continued.
It is noteworthy that after about 10 minutes to make the update touch screen started to show errors, but the system still running. The screen “Routing” not working, but I could make change DCAS aux pre / post, etc. At this moment we are using firmware version 1.43.

if you want to have the event log on my pendrive, and may sent by e-mail.

What is the SBC?

Thanks a lot, and sorry about my english

Solo se que no se nada

[josiaspiconeParticipant]

thank you very much for your reply, I did that a few days ago and it worked wonderfully![]

Solo se que no se nada

[Author]

Posts