[alex.abelParticipant]

+1

[alex.abelParticipant]

+1

[alex.abelParticipant]

+1

[alex.abelParticipant]

+1

I suggested this already in 2018…

[alex.abelParticipant]

+1 for Solo in place function

[alex.abelParticipant]

I also experienced this behavior when patching two analog sources to a stereo channel. One of the channels was distorting and nothing was visible in the metering.
When patching two sources to a stereo channel the expected behavior for me would be that the preamp setting of the two sources will be set equal.

[alex.abelParticipant]

+1

[alex.abelParticipant]

+1!!!

[alex.abelParticipant]

+1
I would like to have ew300-500G4, 2000 and 6000 series integration.

[alex.abelParticipant]

+1

[alex.abelParticipant]

During virtual soundcheck I of course want to hear the mix and single channels on the PA.
To rout the PAFL bus to the PA-Outputs is not really an option, as for example then PA tuning made in the desk is not audible anymore. Furthermore I have to change the output routing everytime I want to hear a single channel and when I then want to hear the entire mix including panning again. Of course I could do this with scenes, but an SIP-function would simplify that a lot in my opinion.

[alex.abelParticipant]

I would like to have this function mainly for virtual soundchecks. Often I want to pick one specific channel from my mix to check and edit this channel. At the moment I have to mute all other channels in order to hear just one channel. A SIP function would speed this up extremely.

[alex.abelParticipant]

+1

For example a possibility to choose whether to see the scene management in the top corner of the screen or the clock. I often do shows where I don’t need scene management, but a visible clock would be very helpful.

[alex.abelParticipant]

+1 for all your suggestions.

An 8 filter EQ as DEEP processing would be great. Then you would not have to use an effect rack for this and could possibly add more of these EQs.

Also configurable HPF in the busses would be great. At the moment you always lose one EQ band and cannot select the slope of the HPF.

[alex.abelParticipant]

Great ideas!

Furthermore I would like to have something like a personal preset for resetting channels. For example my personal default for the width of the EQ filters or attack and release time of the compressor are different from dLive default settings. It would be great to set my personal defaults for resetting channels. At the moment I always have to recall library settings after resetting a channel or mix.

[Author]

Posts