QU16 USB I/O Routing doesn't work

Forums Forums Qu Forums Qu troubleshooting QU16 USB I/O Routing doesn't work

This topic contains 4 replies, has 2 voices, and was last updated by Profile photo of mr. y-mun mr. y-mun 4 months, 1 week ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #105393
    Profile photo of mr. y-mun
    mr. y-mun
    Participant

    Hi guys,

    for Recording with QU-Drive Multitrack I want to route the input of ST1 L on Channel 11. I don’t know why, but it doesn’t work.

    Already if I go to QUDrive page on the onboard screen, I see, that no signal comes in.

    Any ideas what I’m doing wrong?

    Looking forward for your support.

    Best regard s

    Thomas

    #105395
    Profile photo of Giga
    Giga
    Participant

    On the usb routing page, have you patched St.L to channel 11 of the recorder ?

    Giga

    #105399
    Profile photo of mr. y-mun
    mr. y-mun
    Participant

    Yes, that’s what I did. but I don’t get a signal on the track. May be I forgot a detail, but I don#t know which.

    #105414
    Profile photo of Giga
    Giga
    Participant

    If you PAFL the ST channel by itself, do you have signal ?

    Is the pan-setting in your ST channel ok ?

    Have you tried to increase the trim for channel 11 ?

    Giga

    #105431
    Profile photo of mr. y-mun
    mr. y-mun
    Participant

    Yes, there’s signal on that channel
    The pan setting is in center
    The trim is pretty high.

    Thomas

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.