Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • 2023/01/23 at 9:08 pm #111071
    Profile photo of necos
    necos
    Participant

    Can you please describe step by step in details how to:
    1. pink noise on SQ.
    2. modify EQ base on pink noise
    I need to do FOH and monitors.

    I could not find any good explanation at all.
    regards,

    2018/03/14 at 5:59 pm #69599
    Profile photo of necos
    necos
    Participant

    Hi Prhode, i don’t feed sub from main out, I use aux 9-10 for.
    Thus i have complete control on sub vs top and they don’t interfere with each other. Many pro sound engineers use this technique.
    I use 4 QRX218s powered by few crest CA12 connected to EP1 crossover.
    Other AUXs can be used as well which is easy configuraiton on QU or any other mixer.

    2017/08/31 at 4:47 pm #65072
    Profile photo of necos
    necos
    Participant

    I am experiencing same issue.
    i would like to use QU-24 as monitor mixer , so i need direct out to be sent to FOH.
    Unfortunately i could not find how to configure it.
    Before i use to use Midas Venice.

    this link seems not helful.
    https://support.allen-heath.com/Knowledgebase/Article/View/1142/201/how-do-i-route-audio-to-and-from-my-qu-mixer-and-the-daw

    2017/03/01 at 7:46 pm #61707
    Profile photo of necos
    necos
    Participant

    Are you in New Jersey ? I can do sound for you.

    2017/02/20 at 2:57 am #61454
    Profile photo of necos
    necos
    Participant

    As i said previously all faders involved in position 0(-5) db, including master
    When in mode PRE it will be pretty much loud in POST situation is drastically different. All effects are off.
    it`s a simple test. The only way to balance it is to play with gain on the channel.
    Dick, thanks for your post. Of cause i fully realize that digital world is different and now i have to implement different mindset.For the last 4 days i have Qu i really really love it,… except this issue yet. 🙂

    Thanks everyone for feedback

    2017/02/19 at 11:33 pm #61447
    Profile photo of necos
    necos
    Participant

    Thanks everyone for feedback , but i suspect that i did not express my self correctly.
    So here is step by step.
    Connect power monitor with volume 60% on to Mix1
    Bring up Mix1 channel 1 fader to 0 or 5 db. Do same thing on Mix1 master fader to route signal to monitor.
    Connect microphone to channel 1 and push channel 1 fader to 0 or 5
    Now: when you are in PRE, output volume from monitor will be pretty much OK (means enough loud), when in POST it will be at least 20 DB less.
    That’s what my post is about. On MIDAS i had enough room to push up volume in POST mode, not on QU.

    regards.

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)