Replies Created | Forums | I am | Allen & Heath Digital Community

I am

active 2 years, 7 months ago

Forum Replies Created

Viewing 15 posts - 16 through 30 (of 65 total)

← 1 2 3 … 5 →

Author

Posts
2017/10/25 at 2:32 pm #65865

I am
Participant

Thank you.

2017/10/24 at 9:09 pm #65842

I am
Participant

I have both of my computer and have tried all three. I have two USB 3.0 and one USB 2.0.

2017/10/22 at 11:06 pm #65809

I am
Participant

It’s not in device manager.

2017/10/19 at 2:02 pm #65736

I am
Participant

Thank you. I will try it when I get back.

2017/10/19 at 12:27 pm #65734

I am
Participant

Why did you even bother commenting if that’s the best you can come up with.

2017/10/18 at 11:22 am #65704

I am
Participant

My operating system is windows 10. I am trying to remove everything off of the computer I am going to use for office purposes. I have had to purchase another computer for USB B streaming. Without success I might add.

2017/08/20 at 1:11 pm #64883

I am
Participant

Cool.

2017/08/19 at 8:28 pm #64881

I am
Participant

Did you configure the I/O tab in setup on the GLD 80?

2017/08/19 at 8:14 pm #64880

I am
Participant

On your Dante soundcard how many channels do you have selected to be available?

2017/08/01 at 11:13 pm #64599

I am
Participant

So if I replace the 5400 rpm hard drive with an SSD. What is the preferable megabytes per second for the disk?

2017/07/31 at 11:46 pm #64574

I am
Participant

How many megabytes per second should the ssd be?

2017/07/29 at 4:07 pm #64515

I am
Participant

I was also looking for a new computer as my HP with intel and one USB controller is a bust. Is 5400 rpm satisfactory for hard drive speed? It is AMD across the board no intel and it has USB 2.0 with 12GB RAM. Thanks.

2017/04/06 at 12:13 am #62690

I am
Participant

Well I’m in set up utility and for USB 3.0 configuration in pre-OS I have either in Enabled or Auto no disabled. It says when this option is set to enabled bios will configure USB ports to USB 3.0 controller. When the item is set to auto , bios Will configure USB ports to USB 2.0 controller in pre-boot . After booting to OS the USB ports will be switched to USB 3.0 controller. It is recommended to set to auto when installing OS which does not have native USB 3.0 driver such as windows 7 via USB optical device. I don’t see any other settings unless I’m in the wrong place .

2017/04/05 at 12:25 pm #62661

I am
Participant

No I just received this this morning and I was wondering what you thought . I’m not going to uninstall it as some people have said that that didn’t work but that going into bios and disabling it did . I will do that when I get home .

2017/04/05 at 9:57 am #62653

I am
Participant

https://forumsarchive.presonus.com/posts/list/33427.page
Author

Posts