[nutsusaParticipant]

I don’t know if there was a discussion before, but I want the out phase inversion function.
If I want to use a JBL speaker that is out of phase by default with other speakers, I have to have a number of reverse adapters.
If you have a lot of circuits, I bring dLive.
I want to easily reverse the phase of the output with SQ.

[nutsusaParticipant]

I want the effect return to be able to narrow the width of the PAN.

[nutsusaParticipant]

I also agree with the ability to route effects to channels.
That’s because there are times when you want to narrow the PAN width of the effect return or make it MONO.
You just need to be able to narrow the width of the PAN for the effect return.

[nutsusaParticipant]

I also ran into these problems.
I used AudioEase’s BarbaBatch software to easily convert BWF data, which is apparently WAV data.
16bits / 44.1KHz, Ch: 1, BWF Converts to 24bits / 48KHz, Ch: mono, WAV.
It’s very convenient because you can convert multiple tracks at once, but it’s a bit expensive to buy new software.
Rename the converted data to TRK01.wav.
The data converted in this way can be played back on the SQ Drive multitrack.
for your information.

[Author]

Posts