[funkcityParticipant]

ALT OUT VOLUME KNOB! Ha. Well?… I knew that…not
The original plan should work but NOBODY can touch that knob
or back of the church, the vestibule and the outside speaker will be altered!
Whew! what a path!

[funkcityParticipant]

No AR Stage box

ALT Routing

The idea was this:
Assign the ALT output to be LR Prefade
Patch ALT to Stereo input 2
Raise Stereo 2 fader in mix 3
Raise Stereo 2 fader in mix 4
(This MIGHT be a mono stereo lockout on AH Qu-16?)
But it works if I patch from 2T out instead of ALT out (albeit post-fader….grrr!)
The block diagram does NOT show a LR Prefade point ONLY a L&R pre/post in the User Guide.
Maybe I just answered my own question????
Maybe there is no LR pre?? as is selectable from the ALT routing menu??
I had to leave the church as the alarm was ready to sound!XVGSXGVVXVC%C$C!

[funkcityParticipant]

Here is what I did today.

1 calibrated all mics and pres so that once balanced balanced I could start with all input faders at -5dB.
I did this for MixLR out and Mix7&8 out.
2. I then set a DCA on the iPad Qu-Pad. I named as “MASTER” and assigned it to Mix LR and Mix 7&8.
(This is NOT PERFECT but it works so far. But I think internal routing needs to be more in depth.
Note: If you think old school, you would just assign the same signal to more busses! Ha! 🙂
3. Rung out the feedback points at both house locations. Parametric and Graphic are way cool here.
4. Set the delay for most natural and intelligible spoken word.

I would love to have a built-in Dugan automixer in this board as I have in the 3 Yamahas I use at work!

And…BTW, for the Yamaha upright piano I installed Helpinstill piano pickups…no feedback, no crosstalk from other nearby instruments, even sound. Out of production for years he again is selling direct-only from Texas. http://www.helpinstill.com Just add a little Qu EQ and it’s very cool!

[funkcityParticipant]

Yes GC You hit it on the head!

[funkcityParticipant]

Good ideas! Thanks gang!
What I’ll try when I get to it tomorrow is to:
1. Assign LR output to the Alt out.
2. Externally Patch Alt out to Stereo 2 in
(I’d like NOT to patch externally but I believe the routing and internal patching will not support that.)
3. Assign Stereo 2 in to a desired mix bus
4. Adjust THAT mix bus for unity gain and proper delay

I have played with the delay and I’ll be able to optimize.
Then I’ll EQ the room.
Stay tuned 🙂

[Author]

Posts