Forum Replies Created
Viewing 12 posts - 1 through 12 (of 12 total)
Viewing 12 posts - 1 through 12 (of 12 total)
Please advice about the Surface control on the Slave,
Can this be right?
For Audio Clock Source, ES = IN fit PortB on iDR32 connect to the RAB2 ES PortB = OUT.
For Control,ES CONTROL PORT fit Port B on iDR32 connect to
NETWORK Port open one of three ports on iDR RACK CPU of iDR10.
Hi Sam,
Thank you for your advice.
For control each audio clock source,does the connection need to be linked
between any Network port at Master and any Network port at Slave?
Thanks,
Yosuke
Thank you for your reply.
Our system on iLive DualRack is used without that setting you point out.
I appreciate your cooparation every time.
We will contact A&HSupport.
Thank you for your advice.
Everything is working.
Thank you for your reply.
My iLive is on bad condition.
Now it has more than 100 Full scene and partial scenes.
The sound from MainL/R is nothing.(AUX,matrix is ok.) but the channel signal is on the merter, I already check that all patching and channel assignment is correct.
After iLive was reboot, all sound was ok.
I thought iLive’s memory processing has a load
That’s why i tried to do the way.
Does this situation concern with memory available?
Now iLive stored is not working depend on the memory space.
Below operation can not
on the situation:Memory Availabel says less than 30%
-Full scene memory can not be stored
-and “SelectAll” on Modify Scene-Scene Contens can not be choiced
So does this scene memory I try to do take up the space more than30%?
My suggestion is about processing order.
I hope the processing order would be changed for individual input signal.
(ex.The order of PEQ and Comp could be change.)
Thank you for your advise.
I got it.
I also think AES included a clock signal.
so Audio Sync doesn’t need to be set I’m also not sure.
I got it!
Your expression is easy to image Audio Sync.
Thank you so much.
Hello Sam.
Thank you for your advice.
Each mixrack are connected via PORTB useing ACE.
Now the Slave mixrack has be set as port B from mixer preferences.
I have one question. What is “Audio Sync”?
What if Audio Sync is not set?
Because iLive has being working well without Audio Sync setting.
Yosuke,