SQ-Pad fonction

Forums › Forums › SQ Forums › SQ general discussions › SQ-Pad fonction

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of Jens-Droessler Jens-Droessler 5 years, 10 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2018/06/10 at 4:02 pm #71694
    Profile photo of pfr
    pfr
    Participant

    I’ve been working with the sq quiet a lot the Last weeks. Using the iPad app for stage monitoring and some feature at Foch ,i was wondering if it is possible to have the sq channel select be followed by the iPad app! It would be very useful for et or dynamics . As we can get the layer setup from the sq, this should be possible in some ways.

    Love the console so far

    Sent from my iPad using Tapatalk

    2018/06/11 at 11:19 am #71712
    Profile photo of SteffenR
    SteffenR
    Participant

    this is not possible, because the APP is a separeted surface

    2018/06/11 at 7:05 pm #71737
    Profile photo of Jens-Droessler
    Jens-Droessler
    Participant

    I don’t think it’s impossible. The PAFL does exactly that when pressed on either “surface”, right? So it’s only a matter of software. I even think this is already planned. My clues for that are the picture of the SQ7 with TWO iPads on rests. That only makes sense if at least one of the iPad acts as second screen.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.