SQ 6 MTX output polarity not workin

Forums › Forums › SQ Forums › SQ troubleshooting › SQ 6 MTX output polarity not workin

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of Alex A&H Alex A&H 5 years, 2 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2019/02/22 at 6:52 am #82144
    Profile photo of lukam
    lukam
    Participant

    Hi,

    I was using the sq6 with matrix output for feeding subs and upon system alignment I noticed the polarity switch is doing nothing. The delay is working but polarity not.

    Anyone else noticed that?

    2019/02/22 at 8:05 am #82146
    Profile photo of SteffenR
    SteffenR
    Participant

    wich firmware?

    2019/02/22 at 9:14 am #82152
    Profile photo of Alex A&H
    Alex A&H
    Keymaster

    Hi Lukam,

    Unfortunately, there is no polarity available for the buses at the moment on SQ. The Polarity switch you likely looking at is for the Mix External Input feed into the bus, not the bus itself.

    This feature has been requested previously and may be considered for a future firmware.

    Thanks!

    Alex

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.