Dlive C3500 compatible with Behringer p16m

Forums › Forums › dLive Forums › dLive General Discussions › Dlive C3500 compatible with Behringer p16m

This topic contains 3 replies, has 4 voices, and was last updated by Profile photo of Lishinsky Lishinsky 3 years ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2021/04/15 at 8:07 pm #100708
    Profile photo of fabian.arenas
    fabian.arenas
    Participant

    Hi everyone,

    There is anyway that Dlive C3500 can support Behringer P16M?

    thank you very much in advance for your assistance.

    2021/04/16 at 10:33 am #100714
    Profile photo of Scott
    Scott
    Participant

    I don’t know much about the Behringer, but if it can support Dante, then yes if you have a Dante card in your dLive setup.

    2021/04/16 at 10:35 am #100715
    Profile photo of Showtime
    Showtime
    Participant

    It can be done with the p16-i but the me-1 or me500 is a better solution.

    Richard

    2021/04/16 at 2:02 pm #100719
    Profile photo of Lishinsky
    Lishinsky
    Participant

    I actually do it all the time!
    I use RedNet 3 units to convert Dante from dlive to ADAT optical that goes into p16i units and then distributed to the p16m.
    Works great and allows me to connect multiple sets of p16 universes, if you use 2 x RedNet 3 units you can run 4 p16 universes.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.