Dante is 48khz, gigaace is 96 khz.

For split giga ace is a beter choise, for recording waves is a beter option

I mean that if it is possilble to connect a poe switch to the slink card and the me-1 to the poe switch.

The same as to the monitor port of the ar2412.

Richard

firmware v1.3 is needed?

Can i connect the me-1 thru a poe switch directly to a slink bus?

Richard

The only option is to use the ar2412 or ab168 stagebox.

Richard

A gld80 also will the fx’s you need do.

Richard

Witch size are the touchscreens that you are using?
Richard

I think 1 for the network connection and 1 for the dsnake connection.

Richard

Same problem here with the main parameter rotery, i presume that the rotary itselve needs replacemend.

Richard

At this moment there is a gap between sq and dlive. On a facebook sq forum was a message that gld is official end of life. Service and parts available for about 5 years. I hope that there will come a replacment. the sq range is less flexible then the sq, less fx’s then gld.

The first dante card’s are now available, sq card end of august, waves card for the sq is very quit at this moment.

If the waves card is a problem you have to wait.

@keithjah

Is there a timepath? v1.3 and deep units.

Cheers,

Richard

@vogelch You could get a second hand gld80 with ar2412 and ar84, they go for really nice prices these days.

Richard

@keithjah I hop you implement ganging with choise to gang hardware gain, this is something i still mis at the gld.

Richard

@Keith

Is the firmware 1.21 dante card ready?

Richard

In my opinion if the sq now misses features that you think that you will need to do you job, then the sq isn’t the right board for you.

If you need features of the dlive than you have to buy dlive.

Otherwise the gld is also a good board.

As far as i know, the dante card wil be august, v1.3 q3, i think also august so the update for the dante card is in it.

The r&d department has a lot of work to fix some bugs, solve some problems (libary manager) ad some more features, developing the dante, waves and slink card.

The offline editor, there was written that it will take a long time,…[Read more]

Waves3 is 96khz Dante with letterbox is 48khz.

Best options is a waves3 in the console and a giga ace card in the stagerack.

With a giga ace card you can split to a sq console, qu is digital with dlive not possible

Richard

You can use the dx hub to connect three dx 168 stageboxes, you have then 48 ch in and 24 ch out.

If you want to use the me-1 in this configuration you have to wait till the slink card is available. you can use 1 connection on 96 khz and 1 one on 48 khz for me-1

I still hope that there is a new stage box in development that run’s 96khz with a…[Read more]

WAVES

This one fites into the me-u

Richard

Make a split for the vocal mic’s three channels foh and three channels monitor.

Richard