SQ to DLive

Forums Forums SQ Forums SQ general discussions SQ to DLive

This topic contains 20 replies, has 9 voices, and was last updated by Profile photo of PeterM PeterM 3 weeks, 5 days ago.

Viewing 15 posts - 1 through 15 (of 21 total)
  • Author
    Posts
  • #68392
    Profile photo of acs680
    acs680
    Participant

    To link an SQ to a one surface DLive C class using S link, what do I need on the DLive side?

    #68393
    Profile photo of Art
    Art
    Participant

    A GigaAce connection.

    #68396
    Profile photo of Steffen R
    Steffen R
    Participant

    to be clear a unused GigaACE connection, that means a fibreACE or gigaACE card
    or using the Surface link…

    #68405
    Profile photo of ddff_lv
    ddff_lv
    Participant

    But in theory also DX port should work or is it coming later? I know it does not work in practice, just checked.

    ddff

    #68407
    Profile photo of ddff_lv
    ddff_lv
    Participant

    Update: it works also from DX port of dLive, just the patching is shown with zebra square as if the patch would not be possible. And I had to wait 2 minutes to sync.

    ddff

    #68408
    Profile photo of ddff_lv
    ddff_lv
    Participant

    No, it is not working correctly- channels are shuffled and repeated. Even with diagonal patch ip 1, 5, 9 and 13 has same signal, and 4, 8, 12, 16 are silent. So it seems next firmware could solve it.

    ddff

    #68410
    Profile photo of acs680
    acs680
    Participant

    Ahh! You got my hopes up for nothing. I just sent a proposal to the powers that be for an SQ and a gigaAce card for our DLive. Is there some hard evidence this DX capability is coming?

    #68411
    Profile photo of Jack_AH
    Jack_AH
    Moderator

    There are no plans at the moment to support syncing an SQ from a DX port.

    Jack

    #68413
    Profile photo of Mfk0815
    Mfk0815
    Participant

    Boah that would be fine. Connect the SQ via DX port to pass the inputs from the dLive to the SQ and also use the SQ as an input extender for the dLive. That would be great.

    #68414
    Profile photo of Steffen R
    Steffen R
    Participant

    it’s not announced
    SQ can connect to DX expanders

    #68416
    Profile photo of ddff_lv
    ddff_lv
    Participant

    Yes, I also think if SQ can communicate with DX168 and DX32 it would make sense to be able to connect it to DX port of dLive.

    #68417
    Profile photo of ddff_lv
    ddff_lv
    Participant

    Also, a limitation to 32 ch of SLink is not a good thing, if gigaAce is used as signal source.

    #68418
    Profile photo of Mfk0815
    Mfk0815
    Participant

    The SLink port supports up to 128 Channels in and 128 Channels out.

    #68427
    Profile photo of ddff_lv
    ddff_lv
    Participant

    Patch window stops at 32.

    #68428
    Profile photo of DavidCo
    DavidCo
    Participant

    Try the other three SLink pages

    DC

Viewing 15 posts - 1 through 15 (of 21 total)

You must be logged in to reply to this topic.