[zoli0dbParticipant]

“Hope Springs Eternal” 🙂

[zoli0dbParticipant]

+1
It would also be nice if FX parameters could be programmed into IP6.

[zoli0dbParticipant]

Hi peterzoetermeer, your video is inaccessible can you upload the video again?
Perhaps can you describe which cable you found faulty?
I suspect a similar error with me, a slight bump sometimes causes the error which indicates a hardware failure.
thx!

[zoli0dbParticipant]

Just updated the app, I was hoping that this feature would be included, but unfortunately not… 🙁

[zoli0dbParticipant]

Hi,

Did you checked the 1.5.1 really installed into your mixer?
Check the firmware version on the Utilities/General/Diagnostic page!
My colleague installed it four times by the time he succeeded.

Regards,
Zoltán

[Author]

Posts