1. Select desired Matrix.
2. Press “routing” button.
3. Touch “function” tab (Matrix send) at lower left corner of touch-screen.
4. Select L/R Mains bus as your Matrix source.
I wish people would stop being terse in saying, “read the manual.” The manual for matrix setup is garbage. Thanks Dick Rees. I was trying to manage the Matrix through the mix routing screen (I needed to route Mix 9-10 instead of L/R as described in this original post). As simple as it might sound, selecting the Matrix and pushing Function (which for me had no adequate softkey label next to it) brought up the master matrix setup screen. In my case, I was able to completely configure the matrix in the mix routing but I had not turned up the matrix slider (eye roll) thinking the dB setting in the routing screen should have done the trick.
To be clear, for those new to the board:
To “Select desired Matrix” switch to the layer that has the Matrix listed and push the green Sel button. Then follow the remaining instructions.
