[Juergen569Participant]

I didn’t know that until now. Thanks for the tip!

[Juergen569Participant]

I still miss this feature in Version 1.30

[Juergen569Participant]

According to website of A&H, the USB A is just for Stereo recording and playback.
Connect a PC to USB B to do multitrack recordings via a DAW.
Or use SD card for multitrack recordings on the fly.

[Juergen569Participant]

I discovered the same phenomenon on my SQ5. Firmware 1.5.9

[Juergen569Participant]

Beside the mentioned missing display of connected stageboxes, I also miss the display of inserted extension cards as well as e.g. temperature of the system (the SQ gives more information than the Avantis).
I would like to find these informations in the USER -> Status -> Home screen).

[Juergen569Participant]

Just a small edit to my post: maybe it works with my setup of Avantis and QLXD, because the QLXD are about three years old and not the latest version of hardware revisions.

[Juergen569Participant]

Well, I’m sitting right in front of my Avantis (Firmware 1.25) with 6 Shure QLXD4 connected all on the same network (one router, avantis via network connected to router, once 4 QLXD4 via Netgear 5-port-switch connected to router and once 2 QLXD4 vie Netgear 5 port-switch connected to router).

I can see all QLXD4 in Shure Workbench and on the Avantis. Just updated the QLXD to Firmware 2.04.07.
In the channel Preamp view of the Avantis I can see the RF-Signal, the audio input level and battery-state.

[Juergen569Participant]

You should show us pictures of all the connections between the desks and the stage boxes and the network-components.

[Juergen569Participant]

Connect GX4816 to Monitor-console. Then use Tie-Lines to route the channels to the FOH-console. Monitor-console needs an additional S-Link-Card.
There are videos from Allen&Heath regarding using Tie-Lines.

[Juergen569Participant]

Fully agree. Copy / Paste is a must-have.

[Juergen569Participant]

I would like to know if I would see the inserted cards in the Utility -> Status – Screen (as I unfortunately do not see the connected stageboxes)

[Juergen569Participant]

Found the solution on the Avantis: when you press and hold the RESET button, you can give a nugle to the faders. In GEQ-mode this will flip the fader back to 0dB.
But this method can also flip any fader (Input, Mix, Matrix, etc) either to 0dB or to -00dB, depanding on the direction of the nugle to the fader.

[Author]

Posts