Hi Alex, my apologies I replied via email (which eventually bounced)
I can’t say I saw any noticeable visual indications.
It sounded more like a boost in level from around 300Hz to 1Kish. The level boost sounds band limited. I manually bypassed the main GEQ briefly in an attempt to replicate the fault. I can’t say with certainty the change was identical to the problem.
Main GEQ indication shows as “in” at all times.
Quite random and unpredictable.
The problem is recent.
I had a few other bugs since a recent firmware upgrade.
One scene dropped channel 2. It indicates signal through most of the processing chain but did not output to any busses.
I resolved it by inserting the tube stage and removing it.
Another scene had the vocal sub group pan off centre while indicating pan centre. Problem remained after I reassigned to main LR bus. I panned all affected channels off centre to get by. This is when I first encountered the level or EQ jump. Will check next time I use the scene.
All of the issues seem to have occurred after a reconfigure to monitor desk with associated bus changes.
No noticeable problems occurred whist in monitor desk mode.
With the level jump issue I manually reset the bus and group arrangements back to the original setup I used for the scene before loading the scene I had the most recent problem with.
I reset the mode, aux and groups again yesterday (6th December) I will see how it runs tonight
Regards Hicksy