[chansParticipant]

besides Dante capability, is there performance benefit of the DT over the DX? is the analog pre-amp stage and/or A/D conversion better in the DT?

thanks

[chansParticipant]

i’m having same problem. it had been working fine. now all of sudden, it won’t power on, for some reason. anyone have any ideas?

[chansParticipant]

problem solved.

turns out that the speakers didn’t have the correct source selected. with that set properly, things are working now.

[chansParticipant]

yesterday, there was a valid subscription. but it actually did go away; not sure why. so i powered down the mixer,
and left it at that. today, things look better after powering on the mixer. i’m able to see and adjust the pre-amp
parameters. and speaking into the mic, the gain meter moves accordingly.

but now, i can’t get audio to the speakers. the subscription between mixer to the speakers looks good. but i’m not
confident i did it right. i’ve got a few photos i hope would help.

incidentally, everything is connected to a network switch. so the mixer and DT168 are not directly connected to each
other.

Attachments:

You must be logged in to view attached files.

[chansParticipant]

hello. i have the V3 card and SQ-5. with firmware 1.5.9, the board can see the card fine.
but i think i’m still having problems. i also have the DT168, and the mic input there doesn’t
seem to show up correctly in the mixer. the processing view for the channel has the Socket Preamp
section grayed out. is there an updated firmware for the card itself?

now, i’m completely new to Allen&Heath digital mixing. so this could be user error on my part.
but any guidance would be appreciated. thanks.

-sam

[Author]

Posts