Where in the signal path is the ME-1 fed?

Forums Forums GLD Forums GLD general discussions Where in the signal path is the ME-1 fed?

This topic contains 4 replies, has 3 voices, and was last updated by Profile photo of ct6mblue ct6mblue 6 years, 8 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #41328
    Profile photo of ct6mblue
    ct6mblue
    Participant

    I’m just wondering at what point the signal is fed to the ME-1 personal mixing stations. Post EQ? Post compression? I just want to know what affects the performers onstage after I change something on the GLD.

    #41331
    Profile photo of Chris93
    Chris93
    Participant

    It depends how you have your output patch set up, take a look at the “Monitor” tab in the I/O page. The default is for it to be the channel direct out. I can’t see the bottom half of the editor on this laptop but you can change the direct out pick off point.

    Chris

    #41332
    Profile photo of GCumbee
    GCumbee
    Participant

    I think he also wants to know where that direct out picks off. I don’t have a block diagram handy to see that. That is important.

    #41333
    Profile photo of GCumbee
    GCumbee
    Participant

    That can be set in Processing>routing>direct out. Select which pick point you want. It is a global setting. Affects all channels.

    #41334
    Profile photo of ct6mblue
    ct6mblue
    Participant

    Thanks! That’s exactly what I needed!

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.