Three outputs on QU 16

Forums Forums Qu Forums Qu general discussions Three outputs on QU 16

This topic contains 4 replies, has 4 voices, and was last updated by Profile photo of airickess airickess 3 years, 5 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #66251
    Profile photo of Skeelo
    Skeelo
    Participant

    Hello,
    is there a possibility to get three outputs (L,R,M) out of a QU16 console? My current console is a MIXWizard with L,R, M output. I only want to have beside of LR a further output for another room, which has the same mix like LR.

    Thanks in advance and BR,
    Skeelo 🙂

    #66252
    Profile photo of Giga
    Giga
    Participant

    IOPatch, surface, Alt out, LR, done

    God luck !

    Giga

    #66255
    Profile photo of Skeelo
    Skeelo
    Participant

    Thanks Giga,
    but how can I adjust the volume for Alt out independent of LR?

    Thanks again 😉

    #66257
    Profile photo of MarkPAman
    MarkPAman
    Participant

    There’s a dedicated control nob for this.

    #66258
    Profile photo of airickess
    airickess
    Participant

    @skeelo, the Alt Out output has its own volume pot located just below the headphone volume pot on the upper right hand side of the console.
    You can also use any of the mono outputs of the Qu16 (1-4). Select the mix, bring up all faders on that mix to unity, make sure every channel is POST fade, and then that mix should track exactly the same as your FOH mix. You can then use that mix’s master fader to adjust volume to that separate room. I prefer this method to using Alt Out because there is processing available on the mix output (EQ, Delay, etc.) that can come in handy when needed.

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.