Stereo to Mono Inputs

Forums › Forums › SQ Forums › SQ general discussions › Stereo to Mono Inputs

Tagged: 

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Andimusic Andimusic 4 months, 2 weeks ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2023/12/12 at 9:57 pm #117415
    Profile photo of Andimusic
    Andimusic
    Participant

    Hello everyone,
    Is it possible to set all channels to mono on the SQ5. I can’t switch channels 41/42, 43/44, 45/46, 47/48 to mono. I’ve already tried it in the setup under Mixer Config. Would be very grateful for help!

    2023/12/13 at 12:10 am #117417
    Profile photo of Geoff
    Geoff
    Participant

    I just tried that with SQ Mix Pad running on my PC, and it works fine. I saved the show to a new file on an external SSHD, loaded an older show (from the external drive), and then the most recent one again. 41-48 are once again showing as mono inputs. I haven’t actually tried this with a console, but the editor seems to handle it.

    Are you using an old version of the editor perhaps? I’m using ver. 1.5.0

    Geoff

    2023/12/13 at 9:06 am #117423
    Profile photo of Andimusic
    Andimusic
    Participant

    Now it also worked on the console. It wasn’t enough to just switch to the “Mixing config”, I also had to assign it via “Surface”. Thanks for the tip. I also prefer the app in some cases 🙂

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.