SQ – Output polarity flip. (MATRIX)

Forums Forums SQ Forums SQ feature suggestions SQ – Output polarity flip. (MATRIX)

This topic contains 4 replies, has 4 voices, and was last updated by Profile photo of Mick Tombstone Mick Tombstone 1 week, 2 days ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #103445
    Profile photo of Audiosait
    Audiosait
    Participant

    I think this feature is very necessary, to be able to adjust subwoofers in phase, cardioid, etc.

    And a few more matrix, if that’s possible.

    #103454
    Profile photo of Mick Tombstone
    Mick Tombstone
    Participant

    it’s already there under the processing tab.

    Attachments:
    You must be logged in to view attached files.
    #103476
    Profile photo of ioTon
    ioTon
    Participant

    Hi Mick,

    Attention, you are wrong!
    This Polarity swap is ONLY for the Ext-In!

    NOT for the matrix bus Signal!
    -> See the block diagramm

    Attachments:
    You must be logged in to view attached files.
    #103492
    Profile photo of Rob T
    Rob T
    Participant

    +1 for polarity flip on outputs – it’s also really useful for cleaning up monitor/main alignment

    #103541
    Profile photo of Mick Tombstone
    Mick Tombstone
    Participant

    interesting.
    Thank you for clearing that up

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.