SQ-6 Default Boot Layer

[ceprocksParticipant]

Hello All,

Is there any way to specify any layer other than “A” to boot into? I prefer the default input strips as is/where is on Layer A/B/C but have programmed a custom layer onto layer F and would prefer to default boot into that layer on startup rather than re-programming Layer A. I know it’s a minor thing but I have multiple users that only use one or two inputs on my custom layer that don’t fall into the default strip layout on A and reminding them how to change layers has been an inconvenience at times.

[DanParticipant]

Not sure if what you want is possible rn.

BUT

Just shift all of your layers down one and put the simple 2ch layer as “A”. That way a less experienced person could turn on the board and use it without issue.

Cheers!

[Author]

Posts