Sending Backing track to AR84 output for stage loudspeaker amp?

Forums Forums Qu Forums Qu troubleshooting Sending Backing track to AR84 output for stage loudspeaker amp?

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of Howellsound Howellsound 1 week, 6 days ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #104444
    Profile photo of Howellsound
    Howellsound
    Participant

    Hi, struggling here. Just an occasional user of A&H QU24.
    How do I route a channel with CD on it to an output on the AR84 to feed a backing track to an amp & loudspeaker on stage?
    Any advice appreciated. Thanks

    #104447
    Profile photo of Mike C
    Mike C
    Participant

    Just like setting up a monitor mix.

    Select the mix you want to use, you can make it pre or post fade, with the mix selceted
    the faders are in sends on fade mode, bring up the fader for the channel or channels the
    CD player is connected to.

    For the AR 84 output routing go to the set up IO menu, under the stage box tab select outputs, assign one of the four outputs to be the mix you want to use for the monitor.

    #104448
    Profile photo of Howellsound
    Howellsound
    Participant

    Hi Mike C,
    Great, thank you. I’ll have access to the desk later so give it a try.
    Many thanks
    Dave

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.