QU24 and AR2412 + Speaker setup

Forums Forums Qu Forums Qu general discussions QU24 and AR2412 + Speaker setup

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • #64056
    Profile photo of AshAsh
    Participant

    Hi, this may sound like a silly question but wanted to ask anyway. I am doing a portable setup for an very small event. I have the following
    QU24 mixer
    AR2412 dsnake
    Mackie Speakers.

    I am looking to minimise the amount of wires to the stage from the desk so I was planning to just run a single ethernet cable to the dsnake and then run all the wires from the dsnake, when I realised I need output for the speakers. What I am wondering is can the main L+R output be sent to the dsnake so I can hook the speakers straight to the dsnake.

    Hope this makes sense

    Regards
    Ash

    #64057
    Profile photo of MarkPAmanMarkPAman
    Participant

    Yes

    By default (I think) L+R will be outputs 11 & 12
    And Mix 1 = Output 1, Mix 2 = Output 2 >>>>>>> Mix 10 = Output 10

    You can change what you send & to where in the routing section.

    #64059
    Profile photo of GCumbeeGCumbee
    Participant

    As Mark said.

    We do this all the time on live shows and I’ve done many installs. One CAT cable to stage area. Inputs as normal. Then outputs to powered speakers or amplifiers. Go to I/O patch if you need to change anything. You can see on there what outputs appear at what sockets.

    #64068
    Profile photo of Anonymous
    Inactive

    As above is correct – default isnoutput 11/12. That’s how I run every time

Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.