QU16 matrix

[Anonymous]

Hey Folks

Any ideas on a work-around for the lack of matrix on a QU16? At the moment I am using auxiliaries to run 2 sets of delays for conferencing and it is a bit cumbersome. Is there a way of copying the entire FOH mix faders into the clipboard and pasting them into the AUX’s? It’s a real drag that the QU16 doesn’t have at least a couple of matrixes…and ideas appreciated 🙂

[Anonymous]

You could take AltOut and loop back to ST3, then delay that to the in fills.

If you set Alt Out to be LR-Post, then your main volume does everything as expected.

[Andreas]

Can’t we assign pre/post per mix and channel? I’d try setting all channels to post fader for one mix and all faders to unity. Not tested, but this should give a copy of LR, right?
Sure, using an analogue loopback should work as well.

[Anonymous]

Yes, but changing master volum doesn’t affect the infills if you do that

[Andreas]

ok, missed that one.

[MarkPAman]

Do you have an AR####? If so you can link L&R back in to (for example) 23 & 24. Then select those D Snake channels as the sources for all 3 of the stereo channels, each of which outputs to one of the stereo mixes. That’s 3 pairs of outputs, if you used splitters for that link you’d have 4.

[Anonymous]

Balanced jacks all over the back of the desk for AltOut to ST3 looping…

[funkcity]

Remember
Set the AltOut knob to a desired level and mark it and/or tape it off as
this will determine your send to the ST3 input and ultimately your delayed aux sends!
This is how I run my center of house and back of house church feeds! 🙂
And they all follow the Stereo Master Fader.

[Author]

Posts