Qu-Pad: difficult to grab unset setting "points"

Forums › Forums › Qu Forums › Qu troubleshooting › Qu-Pad: difficult to grab unset setting "points"

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of LKY LKY 9 years, 7 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • 2014/09/16 at 8:41 am #41681
    Profile photo of
    Anonymous

    When using the Qu-Pad it is sometimes difficult to be able to grab the small circles or dots you use to show for example the freq and gain of the PEQ, or the ratio of the comp, or the threshold of the gate. If the respective parameters hasn’t been already set in the mixer, grabbing those dots from the border of the respective frame in the Qu-Pad can be very tricky, even for thin fingers.

    Maybe you can do something about it.
    Thanks in advance.

    2014/09/16 at 11:35 am #41684
    Profile photo of LKY
    LKY
    Participant

    Yes,

    One way I find is to do a reset…

    Then the points are spread out more…

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.