QU-PAC ALT OUT not working correctly

Forums Forums Qu Forums Qu troubleshooting QU-PAC ALT OUT not working correctly

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of Kalle Kalle 4 days, 12 hours ago.

Viewing 1 post (of 1 total)
  • Author
  • #112020
    Profile photo of Kalle

    The audio output of my alt-out is not working correctly.
    I wanted to use the jack outputs to drive an amplifier.
    so I did the following:

    got a TRS (balanced) jack to xlr male and hooked it up. L + R channel.
    then I patched the signal in my case MTX1-2

    on both of the channels I have very low output. left output even more than the right output.
    tested it with a sign gen @ 0dB on mtx 1-2. still not enough signal.
    i also checked the pot meter for alt – out on the PAC no difference.
    checked it with sign gen on L+R and used the 2TRACK out this was OK.

    is there something wrong with the dac? I cannot think of anything else.

Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.