Problems with FX1 and FX2

Forums Forums Avantis Forums Avantis troubleshooting Problems with FX1 and FX2

Tagged: , ,

This topic contains 4 replies, has 4 voices, and was last updated by Profile photo of Rosemary Hudson Rosemary Hudson 2 years, 3 months ago.

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • #102901
    Profile photo of schweini
    schweini
    Participant

    I’m running a new Avantis and I try to setup my show. For me to rehearsal I play back via Dante (64ch card).

    Problem: FX engine 1 and FX engine 2 generate a pulsing signal. All other FX engines run correctly.
    – it happens only with all kinds of reverbs. Other effects run correctly. The noise is different when I change the parameters.
    – Mute FX send and/or FX return: no change
    – unroute FX send and route an AUX as send: no change
    – a feedback can be excluded

    any ideas or solutions?

    #104678
    Profile photo of BehringerOfficial
    BehringerOfficial
    Participant

    Can you try recalling a template show to see if it’s the same? FOH for example

    #104696
    Profile photo of Scott
    Scott
    Participant

    Is the Dante card clocked to the mixer?

    #104697
    Profile photo of schweini
    schweini
    Participant

    The problem is solved: the FX-card was defective. After the provider has changed the card, the desk did what I expected. Thank you anyway!

    #104771
    Profile photo of Rosemary Hudson
    Rosemary Hudson
    Participant

    I used to have this problem too

Viewing 5 posts - 1 through 5 (of 5 total)

You must be logged in to reply to this topic.