MIDI Channel Custom Rotary

Forums › Forums › Avantis Forums › Avantis troubleshooting › MIDI Channel Custom Rotary

Tagged: 

This topic contains 0 replies, has 1 voice, and was last updated by Profile photo of AndIkarus AndIkarus 3 years, 2 months ago.

Viewing 1 post (of 1 total)
  • Author
    Posts
  • 2021/02/02 at 1:55 pm #98533
    Profile photo of AndIkarus
    AndIkarus
    Participant

    Hi!

    On my AVANTIS the custom rotarys 1-3 on a MIDI Channel are not working correctly.
    Custom rotary 1 is sending a MIDI message, but custom rotary 2 and 3 are dead. no messages are sent out although there is a correct entry.

    Please note that for the next firmware upgrade.

    Andreas

  • Author
    Posts
Viewing 1 post (of 1 total)

You must be logged in to reply to this topic.