I am having an issue with the way pre/post is working

Forums › Forums › dLive Forums › dLive troubleshooting › I am having an issue with the way pre/post is working

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2022/09/10 at 11:00 pm #108935
    Profile photo of AllourepAllourep
    Participant

    Hello all. I am using a Drive S7000. When I have a send that isn’t set to “pre”, I cannot for the life of me get any audio to pass. It behaves as if I have it turned off. I have the send turned up 100% and the fader up all the way, I also have the Aux set to ON. Nevertheless, no audio is passing whatsoever. Once I change it over to “Pre” audio passes through just fine. Does anyone know what I am missing here?

    Thanks

    2022/09/11 at 9:06 am #108936
    Profile photo of SteffenRSteffenR
    Participant

    Maybe a corresponding DCA is at -infinity?

    2022/09/11 at 4:43 pm #108942
    Profile photo of AllourepAllourep
    Participant

    Hey Steffen

    Thanks for the reply. Next time I with the board I’ll investigate if that might be what’s going on. Thanks for the suggestion.

    2022/09/13 at 1:00 pm #108967
    Profile photo of msteelmsteel
    Participant

    Or similarly, a mute group.
    Or a mute. But that would have been pretty obvious so you would have probably caught it.
    Or something else in the signal chain like a gate that isn’t opening.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • You must be logged in to reply to this topic.