help Setting up Fx on a chennel

Forums Forums Avantis Forums Avantis troubleshooting help Setting up Fx on a chennel

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of SteffenR SteffenR 5 days, 23 hours ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #101786
    Profile photo of Ernie
    Ernie
    Participant

    Just got the Avantis and tied setting up an Fx on a Channel and I was unable . can someone help me with the steps to Do so?

    #101846
    Profile photo of Scott
    Scott
    Participant

    Put FX sends on a layer. Select “Mix” on the channel that you want to put FX on, and raise the levels on the FX sends as desired.

    You can also press “Mix” on a single FX unit, and send whatever channels that you want to that unit by raising their respective faders.

    #101857
    Profile photo of SteffenR
    SteffenR
    Participant

    can someone help me with the steps to Do so?

    to be honest…
    if you are unable to do this basic procedure on the Avantis,
    then you should think about your knowledge about mixing in general…
    try to find someone who can help you with your basic skills
    or at least you should read the getting started guide

    Or maybe you should rephrase your question if we got it wrong…?

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.