Global Pre/Post Assignment from Individual Mix Master

Forums Forums SQ Forums SQ feature suggestions Global Pre/Post Assignment from Individual Mix Master

This topic contains 5 replies, has 3 voices, and was last updated by Profile photo of SteffenR SteffenR 10 months, 2 weeks ago.

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • #93032
    Profile photo of harrisonhal266
    harrisonhal266
    Participant

    Hello all,

    Is there a way to do a global pre/post assignment from an individual mix master on the SQ? If not, this should definitely be a feature added.

    #93033
    Profile photo of MarkPAman
    MarkPAman
    Participant

    See page 40 of the manual for this bit:

    “Aux – (‘Aux Snd’)
    • Touch the ‘Channel Source’ value to choose the where the aux takes channel signal from. Each source point is presented in order, and is affected by all preceding processing that is switched in.
    • Touch ‘All On’ or ‘All Off’ button to assign or unassign all channels to the aux.
    Touch ‘All Pre’ or ‘All Post’ button to set all channel sends to pre-fade or post
    fade.”

    #93039
    Profile photo of SteffenR
    SteffenR
    Participant

    and not to forget the obvious

    press the mix button (BLUE) then select the master strip
    now you can press and hold PRE/POST on the left hand side and with the master strip select you can toggle pre/post
    and the same with the assign button press and hold you can turn whole mixes on or off

    Attachments:
    You must be logged in to view attached files.
    #93041
    Profile photo of SteffenR
    SteffenR
    Participant

    I was absolutely sure that it was written in the Quick-Start Guide
    but it’s not…

    Reference Manual page 42

    #93044
    Profile photo of MarkPAman
    MarkPAman
    Participant

    Haha – how did I forget that?

    3 months of not using the desk I guess 😫

    #93047
    Profile photo of SteffenR
    SteffenR
    Participant

    I’m with you… know what you mean 😀

    do you remember where the power switch is? 😉

Viewing 6 posts - 1 through 6 (of 6 total)

You must be logged in to reply to this topic.