Dyn8 bypassed

Forums › Forums › Avantis Forums › Avantis troubleshooting › Dyn8 bypassed

Tagged: 

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • 2021/03/23 at 6:28 am #100050
    Profile photo of AdamsFlysAdamsFlys
    Participant

    Not sure if this is the proper place to make this or if there is a bug reporting page, but ever since updating to version 1.10, the dyn8 insert shows “bypass” in red just below the eq/compressor buttons on the left hand side. Several others have seemed to have this problem too

    2021/03/23 at 8:07 am #100052
    Profile photo of Nicola A&HNicola A&H
    Keymaster

    Hi AdamsFlys,

    Yes we had a few reports of this and we are investigating.
    Can you confirm you recalled a Show file after updating the firmware?

    2021/03/23 at 12:29 pm #100063
    Profile photo of AdamsFlysAdamsFlys
    Participant

    Yes, I recalled the show file that was created as a backup immediately before updating the firmware

    2021/03/25 at 1:18 am #100114
    Profile photo of DanDan
    Participant

    Seeing the same thing on my console after upgrading.

    2021/03/26 at 1:36 am #100150
    Profile photo of DanDan
    Participant

    Tonight I found that if I unassigned dyn8 from the channel and reassigned it then the issue was resolved.

    2021/03/28 at 1:43 pm #100208
    Profile photo of DanDan
    Participant

    …but it’s back after restarting the console…

  • Author
    Posts
Viewing 6 posts - 1 through 6 (of 6 total)
  • You must be logged in to reply to this topic.