Direct Outputs to dSNAKE Outputs

Forums Forums Qu Forums Qu feature suggestions Direct Outputs to dSNAKE Outputs

This topic contains 2 replies, has 3 voices, and was last updated by Profile photo of Andreas Andreas 5 years, 1 month ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #56588
    Profile photo of Churst
    Churst
    Participant

    At the moment it’s only possible to send mix outputs to the dSNAKE.
    Would it be possible to send Direct Outputs from each input channel to the dSNAKE outputs and Expander?

    This would allow all 16 mic inputs of the desk to be used with Timecode enabled recorders and may allow better integration with existing studio systems looking for increased preamp track counts in combination with the control surface elements.

    #56602
    Profile photo of [XAP]Bob
    [XAP]Bob
    Participant

    For pure recording you can route each channel to just one mix.

    Since you say 16 mics I assume a QU16?

    Mix1-10, FX1-2, L&R

    #56605
    Profile photo of Andreas
    Andreas
    Moderator

    For studio recording I’d prefer USB to avoid the additional DA/AD stages (signal quality will not improve that way). But I see this could be helpful for special requirements as described.

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.