Connecting Xone:23 to amplifier

Forums Forums ME Forums ME troubleshooting Connecting Xone:23 to amplifier

This topic contains 1 reply, has 2 voices, and was last updated by Profile photo of SteffenR SteffenR 4 years, 1 month ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
  • #90421
    Profile photo of Sara.P

    Not sure if this is the right forum, hopefully someone can help since Im not an expert 🙂 I recently acquired a xone:23 mixer with two channels that I would like to connect two turntables and a nad amplifier where I have two monitor studio speakers (not pre amplified, thats why im not connecting them directly to the mixer). Im connecting the amplifier and the mixer using the aux (amplifier side) and the monitor output (on the mixer side). The problem is when i do this just one of the speakers have sound, the other one is silent. When i use just the turntable connected to the amplifier both speakers work. Can somebody help? Thank you in advance.

    You must be logged in to view attached files.
    Profile photo of SteffenR

    this is the wrong forum, but since no Xone forum exists…

    I guess this is not the problem of the mixer, it seems like a broken cable
    but actually there is not enough information

    normally you would connect the speaker system to the master out
    and only your personal booth monitor speakers are connected to booth or monitor out

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.