Group Meters

Forums › Forums › iLive Forums › Archived iLive Discussions › Group Meters

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of  Anonymous 14 years, 7 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 2009/09/15 at 4:42 pm #22136
    Profile photo of
    Anonymous

    I looked in the manual and did a search on this forum, but didn’t see anything.

    I have several groups set up on faders. I see that the meters above the fader are post fader. Is there a way to make these meters pre-fader? It would be really handy to make sure I’m not overloading the group.

    Thanks!

    Tim Gibson
    Tech Director
    EV Free Church
    Crystal Lake, IL

    2009/09/16 at 11:56 am #24682
    Profile photo of Mr-B
    Mr-B
    Participant

    Tim I think you will find the meters can not be made Pre Fade but if you PFL the group they will display on the PAFL meter or if the group overloads the red LED by the layer button that the group is in, will flash indicating an overload in that layer (as per channel peak).
    However I am lead to believe there is quite a bit of headroom even if the LED flashes momentarily.
    Hope this helps[8D]

    2009/09/16 at 3:58 pm #24685
    Profile photo of
    Anonymous

    Yeah, PFLing works, I just wasn’t sure if there was a check box somewhere I didn’t know about.

    Would be a nice option for a future FW.

    Good to know there’s some headroom there though.

    Tim Gibson
    Tech Director
    EV Free Church
    Crystal Lake, IL

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)

The forum ‘Archived iLive Discussions’ is closed to new topics and replies.