@ryuda1
I would double check a couple areas.
First, go to your input and check the Routing. Make sure then Main LR is “On” and not “Off”. I can imagine a scenario of your Auxes getting output when your input is either pre or post send and your Main LR not getting any output because your Main LR is “off” in the routing for that input.
Second, I’d double check the patch for both input and outputs.
Third, I’d save the scene, then copy to an external thumb drive. I’d suggest doing this before resetting the console to factory default. The. Reload the scene and see if that changes anything.
Fourth, if that doesn’t help, try opening a support ticket directly with A&H.
Good luck.