Forum Replies Created
Viewing 7 posts - 1 through 7 (of 7 total)
Viewing 7 posts - 1 through 7 (of 7 total)
I don’t remember the size, but still remember vividly how I hated A&H when I tried to install my madi card.
I went through 3 different tool boxes and another 3 special toolboxes for small screwdrivers…but after nearly 90 minutes and none of the about 50 torx we had worked…the torx of the leatherman of my colleague finally worked
That was what was the Problem!
I had nothing safed on any of those channels!
Using the actual firmware
(1.5 i believe)
Hmmm…I had a similar problem in the last few days with.
Mixing for a small festival. 4 bands a day.
I made a festival setup with everything patched and saved that scene as starting point for each band.
In the scene safe menue I saved the main l/r and mono bus, talk back, smaart channel…
And I saved the aux-busses for the monitoring, so that GEQ and stuff stay at the latest setting (so that refinements are not reset to the start scene).
In the aux-safe list I un-ticked the “levels” field, so that the levels sent to the monitors are saved and recalled as intended for each band.(what parameters are exactly safed under levels…I have no idea as the manual is…really really really bad)
But: After Soundcheck for each band, when I recalled the starting scene the levels from the channels to the auxes were not changed back to the starting scene!
Oh, and regarding Fitting a Card in the mixer: when I goz my Madi-card i and my colleague had to go trough 4(!) tool cases including 2 special sets of Torq screwdrivers without finding a fitting size!!!
had to go to a hardwarestore with the Card to buy one!
maybe use size that is more commen in future revisions. Cost me 1,5 hours to fitt that card!
Thanks Nicola, that would be one way…but as I have Madi-Card that I use a lot it would be really nice to get a 2412 Version 2 with AES/EBU In/Out 😉
you could use matrixes for that…although you cannot select the steepness of the hicut and low-cut filters in the Outputs…so finding the sweetspot for your Equipment may be quite hard
RTFM
look for the (most likely predefined auxes) on the right Hand side of the mixer)
press the “mix” key of the aux
now all the channelfaders send Signal to this aux when pushed up
(define the Output of the aux in the I/O menu)