IO port screws

Forums › Forums › GLD Forums › GLD general discussions › IO port screws

This topic contains 3 replies, has 4 voices, and was last updated by Profile photo of Mikol Mikol 7 years, 8 months ago.

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 2016/03/22 at 11:00 pm #54711
    Profile photo of I am
    I am
    Participant

    Can someone please tell me what kind of screws are in the IO port lid?

    2016/03/23 at 7:48 am #54714
    Profile photo of Showtime
    Showtime
    Participant

    Something torx 8-9-10 that range

    2016/04/06 at 5:46 pm #54981
    Profile photo of tenderboy
    tenderboy
    Participant

    I don’t remember the size, but still remember vividly how I hated A&H when I tried to install my madi card.
    I went through 3 different tool boxes and another 3 special toolboxes for small screwdrivers…but after nearly 90 minutes and none of the about 50 torx we had worked…the torx of the leatherman of my colleague finally worked

    2016/07/31 at 1:52 am #57459
    Profile photo of Mikol
    Mikol
    Participant

    Its a T8. Just did a Dante card install 2 weeks ago and had to run to the store. My bit set only went as low as T10… ugh.

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)

You must be logged in to reply to this topic.