Forum Replies Created
-
AuthorPosts
-
2011/01/25 at 7:59 am #27114
Hey Thanks Guys! I also think that we need to share experiences here.
I got answer from help desk that problem could be bad ground.. I checked all my elec. cables and the one I was using in FOH was broken.. Sometimes it had ground, but when in right position it lost ground.. So have to check cables at least 2 times in year
But I think this was problem because I never had any bigger problems with table.. And A&H support was also very fast with answer. Thanks.2011/01/20 at 10:44 am #27087Of course I call the dealer. But also it would be nice to hear, if somebody have had the same you know. This wasn’t suppose to be any insult to Ilive or nothing like that.
Just to hear if somebody have had samekind of issues… After all this is forum about Ilive? Isn’t it?quote:
Originally posted by albinMy honest opinion: why do you post something like this in the forum? Do you think this is normal behavior and can be fixed somehow? There is something wrong with your System and this is shurely something for tech support.
So go ahead – call your dealer.2010/09/13 at 11:22 pm #26375info at aanimaisema.fi
They have T112 and T80, you can ask if its free at time you need it.
2009/10/10 at 5:26 pm #24767quote:
Originally posted by josiaspiconeHello
I used in this way: I send teh signal by two mono groups, and unassigned that channel from Mains, then I turn on one compressor.
Sorry about my Tarzan style english[]
Solo se que no se nada
Thanks!! That’s one to do that.
Mika
2009/10/09 at 5:47 am #24763Hi!
I’m double bussing because of compression… Like parallel compression.
Like keeping the channel clean and then compressing hell out of bus, and
then mixing them. So you got much more dynamic sound, but still tighter.
And I know why this comb filttering is coming. But it’s usually fixed with things like
delay compensation.. At least in reccording softwares .. I can check today does nobody else’s console have this same problem.
Because I’m now at audio fair.. And here’s lots of digital desks..
And here’s a link for you Darren, if you haven’t heard of parallel compression….
https://en.wikipedia.org/wiki/Parallel_compression2009/06/28 at 8:22 pm #24393I was also wondering this..https://www.ilive-digital.com/forum/topic.asp?TOPIC_ID=832
This is for also pain in the ass.. It’s pretty difficult to program anything for live show…
Hope it changes in new firmware.2009/05/19 at 9:48 pm #24328I think you maybe missed the point? I wasn’t also so clear.
But let’s try again.I have Song Number one. Where I have 8 FX. FX 1 is for drums and FX 2 is for TOMS. So I send Snare and Toms to FX 1. And TOMS only to FX 2. Then Song Number Two. I have 8 FX. But this time FX 1 is for drums. And FX 2 is for Kick Drum. So FX 1 send is same that before, but now I only send Kick to FX 2, not TOMS. And when I make this happen on Song Two and then recall song one. Ooops. Now the sends are still like they were in song two. It goes if i’m choosing like mix channe processing in the scene editor with it, but I don’t want to change any other levels. I only want to control FX changes and sends. Sorry for my bad english and very stupid first message.
Mika Jokela
+358-407430404 -
AuthorPosts