[maddog-wareParticipant]

That’s not the answer I wanted to hear 😀 Does this liquid conduct or can it etch the conductors?

I will measure the current once with a new battery in the off state. I can also check the charging voltage once.

[maddog-wareParticipant]

Dear Sparky,

there is a VARTA 2.4 battery on the mainbord of the MixRack. That should hold the memory of a SRAM – here are your settings of routing, your show in general. I think the clock is powered from this battery, too.

I replaced it, but I got still problems, loading previous settings / show on power up.

best regards,
Jan

Attachments:

You must be logged in to view attached files.

[maddog-wareParticipant]

Dear Bärchen,

thanks for your reply. I already did. The old one was weak and did not look good. It worked for three Days. The new one had 2.5V and now dead again. That seems very quick to me, normally the backup battery should last at least months without AC power.

The clock of the IDR48 does not run even if the device is switched on. After power loss, an empty show is always loaded. A specific start show is not set.

best regards / liebe Grüße,
Jan

Attachments:

You must be logged in to view attached files.

[maddog-wareParticipant]

Hi,

same issue here. Do you solved it?

best regards

[Author]

Posts